Our Range
of Products

ADVANTAGES

  • Very tough and hard wearing coating
  • Interior and Exterior applications
  • Highly washable
  • Able to be catalysed where necessary

Polyurethane Enamel

WeatherPrufe POLYURETHANE ENAMEL: A premium grade Polyurethane-Alkyd based coating for Interior and Exterior applications. Superior abrasion and chemical resistance properties make this product ideal for the most demanding interior floor and wall applications.

 

SPREAD RATE
Spread rate is dependant on the porosity and profile of the substrate. Typically spread rates of 10 square metres per litre are achieved.

Application

Apply to suitably primed or sealed and DRY substrates.  Can be applied to previously painted surfaces.  Water-based paints can be over coated directly.  When over coating Gloss Enamel, it is necessary to sand the old coating down to an even, matt finish before applying this product.  MOISTURE LEVELS IN SUBSTRATE SHOULD NOT EXCEED 15%.

Can be used on cold room cement floor screeds where temperatures do not fall below 5˚C.

Cement: Walls

Prime unpainted friable masonry surfaces with one diluted coat of WeatherPrufe Polyurethane Enamel, diluted 5% with mineral turpentine, at a spread rate not exceeding 8 sqm per litre and allowed to dry overnight. Once dry, apply two coats of WeatherPrufe Polyurethane Enamel, at a spread rate of 10 sqm per litre, allowing a 6 - 8 hour drying time between coats.

Cement: Floors

To both friable masonry surfaces and unprimed stable surface, apply one coat of WeatherPrufe Polyurethane Enamel, diluted 10% with mineral turpentine, at a spread rate not exceeding 8 sqm per litre and allow to dry overnight. Once dry, apply second coat of WeatherPrufe Polyurethane Enamel, diluted 5% with mineral turpentine, at a spread rate not exceeding 10 sqm per litre and allow to dry overnight. Apply the final third coat, at a spread rate not exceeding 10 sqm per litre and allow to dry overnight. This will increase the life expectancy of the coating.

Metal

Prime metal surface with WeatherPrufe Etch Primer and allow to dry for 6 hours. Once dry, apply two coats of WeatherPrufe Polyurethane Enamel, at a spread rate note exceeding 10 sqm per litre, allowing a 6 – 8 hour drying time between coats.

WoodPrime wooden surfaces with WeatherPrufe Wood Primer and allow to dry for 6 - 8 hours. Once dry, apply two coats of WeatherPrufe Polyurethane Enamel, at a spread rate not exceeding 10 sqm per litre, allowing a 6 - 8 hour drying time between coats.

 

FULL CURING TIME:  36 HOURS (with ambient temperatures from prep, coating and curing not falling below 12 degrees Celsius)

Approved by the Wine Industry

Contact Us Now »